External View - Toshiba Carrier RBM-Y0383FUL Manuel D'installation

External view

<RBM-Y0383FUL, RBM-Y0613FUL>
Outdoor unit side
Refrigerant pipe connecting port (Discharge gas)
Refrigerant pipe connecting port (Liquid)
Refrigerant pipe connecting port (Suction gas)
6.3" (160)
0.83" (21)
1.73" (44)
3.43" (87)
<RBM-Y0963FUL>
Outdoor unit side
Refrigerant pipe connecting port
(Discharge gas)
Refrigerant pipe connecting port (Liquid)
Refrigerant pipe connecting port
(Suction gas)
(4.73" (120))
7.88" (200)
1.10" (28)
2.20" (56)
3.7" (94)
EN-9
12.6" (320) (Hanging bolt pitch)
Refrigerant pipe connecting port (Liquid)
9.77" (248)
Refrigerant pipe connecting port (Gas)
Ø0.87" (22.2)
Knockout hole for power wiring
(4.73" (120))
(4.73" (120))
(4.73" (120)) 5.39" (137)
2.13" (54)
2.95" (75)
18.5" (470)
15.8" (400)
Refrigerant pipe connecting port (Gas)
Refrigerant pipe connecting port (Liquid)
(4.73" (120))
- 5 -
Installing hanging bolts
• Considering piping and wiring after hanging the Flow
(Unit: in (mm))
Selector unit, determine the installation position and
direction.
Indoor unit side
• After determining the installation position of the Flow
Selector unit, install the hanging bolts.
• For hanging bolt pitch, see the External view.
• When the ceiling is installed, draw the pipes to the position
where they are to be connected before hanging the unit.
Ceiling preparation
Because ceiling preparation depends on the building structure, consult with the architect or interior finisher.
After removing the ceiling panels, it is important to reinforce the ceiling frames to prevent ceiling panel vibration and to
Ø0.79" (20)
keep the ceiling horizontal.
Hole for control wiring
Installation of hanging bolts
Use 3/8" (M10) hanging bolts (2 pcs., to be local procure).
Matching to the existing structure, set pitch according to size in the unit external view as shown below.
Install the bolts with insert brackets or
anchor bolts.
Use existing angles or install new support
Indoor unit side
angles.
Use a hole-in anchors, hole-in plugs, or a
hole-in bolts.
Ø0.87" (22.2)
Knockout hole for power wiring
Ø0.79" (20)
Hole for control wiring
2.64" (67)
3.70" (94)
6.93" (176)
Procure hanging bolts and nuts locally for installing
the unit.
Hanging bolt 3/8" (M10)
Nut 3/8" (M10)
Flat washer 3/8" (M10)
New concrete slab
(Blade type (Slide type (Pipe hanging
bracket) bracket) anchor bolt)
Steel frame structure
Hanging bolt
Support angle
Hanging bolt
Existing concrete slab
2 pieces
6 pieces
4 pieces
Reinforcing
steel
Anchor bolt
EN-10