Toshiba Carrier RBM-Y0383FUL Manuel D'installation page 12

Connections
High Static Ducted Type (MMD-AP***H2UL Series)
CAUTION
Connect the wire to the lead wires with wire joint on the (L1), (L2) terminal block for power supply, using the following
procedure:
Cut the wire joint on each lead wire, and cut the faston ((L1) and (L2)) on the attached wire (power supply).
Then check the (L1) and (L2) phases, and connect the wire and the lead wires with the attached wire joints.
Indoor P.C. board
CN81
(Black)
Secure here.
Attached wire
(FS unit control
wiring)
Ground screw for Flow Selector unit
Knockout hole (for FS unit
power supply wire)
EN-21
Wire joint (Attached)
(L1), (L2) terminal
Ground Power supply
block for power supply
screw
Attached wire
(FS unit power
supply)
Attached wire (FS
unit control wire)
Bushing (for control
wires) Cord clamp
Conduit pipe (for indoor
unit power supply)
Conduit pipe (for FS unit power supply)
- 11 -
4-way Cassette Type (MMU-AP***H2UL Series)
Ground screw
Ground screw
Bushing (for control wires)
Knockout hole (for FS
unit power supply wire)
Attached wire (FS
unit power supply)
Conduit pipe
Conduit plate
Indoor P.C. board
(L1), (L2) terminal block
Faston connection
for power supply
Clamp with remote controller lead wires
Attached wire (FS unit control wiring)
Attached wire (FS unit power supply)
Power supply
Conduit hole
(for indoor unit
power supply)
Lock nut
Conduit pipe (for indoor
unit power supply)
CN81 (Black)
Attached wire (FS unit
power supply)
Attached wire
(FS unit
control wire)
Conduit pipe (for FS
unit power supply)
EN-22