Domo DO938K Mode D'emploi page 39

it flat as this may damage the coolant system.
ews at rear side of top cover. 2 people handle the unit during assembly.
2. Remove the top cover.
ews at rear side of top cover.
er and thermostat knob, then place it aside.
er and thermostat knob, then place it aside.
er and thermostat knob, then place it aside.
ge and then remove door and place it on a soft pad to
3. Remove the three screws and then remove the top hinge that holds the door in place. Lift the door
and place it on a padded surface to prevent it from being scratched.
ge and then remove door and place it on a soft pad to
ge and then remove door and place it on a soft pad to
hinge. Then remove the adjustable feet from both
hinge. Then remove the adjustable feet from both
4. Remove the bottom screw, hinge bracket and adjustable feet from the bottom of the appliance.
hinge. Then remove the adjustable feet from both
Reverse Door
5. Take the hinge pin out of the hinge bracket. Turn the bracket around and tighten the pin again.
5. Unscrew and remove the bottom hinge pin, turn the bracket over and replace it.
6. Refit the bracket fitting the bottom hinge pin. Replace both adjustable
feet.
www.domo-elektro.be
7
7
7
Unscrew
unscrew
unscrew
Screw
DO938K
39