Caloric CVU306C-SS Manuel D'utilisation Et D'installation page 17

Troubleshooting
If the range hood or light
does not operate after
installation:
The range hood vibrates
when the suction is on:
The suction or fan seems
weak:
The lights work but the
motor is not spinning, is
stuck or is rattling.
The hood is not venting
smoke efficiently:
Note:
For all other inquiries, please contact us at: 1-844-455-3474 ext. 2 or service@caloricappliances.ca
• Check if the range hood has been plugged in, make
sure that all power has been turned back ON, and
all electrical wiring are properly connected.
• Replace the light bulbs to determine whether it is
caused by defective bulbs. See Replacing the light
bulbs on Page 19.
• The range hood might not have been secured
properly on to the ceiling or wall. Check with your
installer
• Check that the duct sized used is at least 6" or 3 ¼"
x 10". Range hood WILL NOT function efficiently
with insufficient duct size. For example: 7" duct
over 6" hole and loosely secured.
• Check if duct is clogged or if damper unit
(half-circular flapper) is not installed correctly or
opening properly. A tight mesh on a side wall cap
unit might also cause restriction to the air flow.
• The blower might be jammed or scraping the
bottom due to shipping damage. Please contact
us immediately.
• Make sure the distance between the stove top and
the bottom of the hood is within 28" and 31" in
distance. *Due to different ceiling height
configurations, recommended height may not be
applicable.
• Reduce the number of elbows and length of duct
work. Check if all joints are properly connected,
sealed, and taped.
• Make sure the power is on high speed for heavy
cooking.
Pg 16