Publicité
Les langues disponibles
Les langues disponibles
(STEP 6 cont.)
tap into an existing 12V circuit that can handle the additional load of the booster (less
than 2 amps).
■ For safety, turn off the power. Before working on the electrical system, turn off the
main 12V power switch or disconnect the RV from shore power and battery to prevent
electrical hazards.
■ Install the inline fuse holder. If using an existing circuit, identify the positive (red) wire of
the circuit you'll be tapping into. Cut this wire to insert the inline fuse holder. Strip about
1.3 cm of insulation from both ends of the cut wire and the fuse holder wires.
■ Connect the inline fuse holder. Use butt connectors or wire nuts to connect one end
of the inline fuse holder to the power source wire (from the distribution panel) and the
other end to the wire leading to the booster. Crimp the connectors securely and cover
the connections with electrical tape or heat shrink tubing. Insert the included fuse into
the fuse holder.
■ Connect the Ground Wire. Find a good grounding point near the booster unit, such as
a chassis ground or the negative bus bar in the distribution panel. Connect the ground
wire to the grounding point.
20
20
ENGLISH
Publicité
