weBoost Drive Reach RV II Guide D'installation page 16

(STEP 3 cont.)
Option 3: Installing Cable Entry Cover
Select a suitable location on top of the RV that
provides a clear path for the cable. Drill a hole
that the cable and connector will fit through into
the RV. Insert the cable into hole and apply roof-
compatible sealant around the hole and cable.
Also apply sealant on the bottom edges of the
cable entry cover before securing it to the RV roof
with suitable fasteners (e.g., lag screws, well nuts,
sheet metal screws, toggle bolts, t-anchors).
When the cable entry cover is secured properly
apply additional sealant around the edges and
check for any gaps to ensure a watertight seal.
You Will Need
Drill and drill bit
Mounting hardware
13
ENGLISH
Roof sealant
Outside Antenna
drilled hole filled
with sealant
Cable Entry Cover
& Mount
apply roof-compatiable
sealant on bottom &
edges of gland
fasteners/screws to be
determined by installer