Maxi-Cosi Emerald 360 Pro Mode D'emploi page 95

EN
your child is from 76 cm up to 105 cm in length
and older than 15 months.
• When the child restraint is installed in the
maximum rearward facing position, it may not
fit in all approved vehicles. Please check that
all possible positions of the car seat (recline
positions and headrest adjustment) fit in
your car.
WARNING:
• It is MANDATORY to install the support leg when
your child's height is from 40 cm to 105 cm.
• The ISOFIX anchors have been developed
to obtain a safe and easy fixation of the child
safety systems inside the car. Not all cars are
equipped with these anchors although they are
standard on more recent models.
• The car seat must always be locked in the forward
facing or rearward facing position when travelling
with the child in the car seat. Do NOT travel when
the car seat is rotated to a lateral (loading) position
or to any other unlocked intermediate position with
your child in the car seat.
• When installing the car seat, spaces between
the base of the car seat and the vehicle seat
are possible depending on the position of the
anchorage points within the vehicle.
• Use the car seat only on a front-facing seat that
is fitted with an automatic or static 3-point belt
that has been approved according to the ECE R16
standard or similar. Do NOT use a 2-point belt.
I
95 Emerald 360 Pro 40-150 cm
I
Maxi-Cosi
For a child from 100-150 cm:
• Install the car seat with the vehicle belt and
ISOFIX connectors when your child's length is
from 100 to 150 cm. It is NOT recommended to
install the car seat with vehicle belt only.
• The support leg must be folded under the car
seat when your child is using the vehicle
safety belt.
• When using the car seat with the vehicle belt,
only the forward facing position is allowed and
it is NOT possible nor allowed to rotate and slide
out the car seat.
Your child in the Emerald 360 Pro
car seat:
• The newborn inlay included in your Emerald
360 Pro seat plays an integral part in the
efficiency of the restraint system for your child
from 40 to 75 cm. It can be removed, and the
cover taken off for washing, but it is essential
to place it back again where it belongs and only
use this official Maxi-Cosi Emerald 360 Pro
newborn inlay. This newborn inlay is exclusively
for use with the Emerald 360 Pro seat.
• The newborn inlay is MANDATORY for a baby
from 40-60 cm. From 60-75 cm you can choose
to remove the inlay if your child no longer fits.
• Always make sure to remove the inlay when
your child's length is more than 75 cm.
• Make sure you can fit no more than one finger
between the harnesses and your child (1cm).
If there is more space than 1 cm, tighten the
harness belt further.