Omnifilter RO-2050 Instructions D'installation page 5

Base O-ring Seat
B
Will Spring Open
Figure 4
C
Notch For Faucet
45°
Handle Faces This Direction
Figure 5
D
E
Figure 6
5. Installing the Drain Clamp
Black Rubber
NOTE: If you have a single-basin sink with a disposal unit, call
Washer
Customer Support for options .
NOTE: Before installing the drain clamp, check the drainpipes under
the sink for corrosion . Corroded pipes should be replaced before
continuing with installation .
A) Attach the drain clamp to a vertical section of the drainpipe,
about 6" above the trap . Make sure the opening on the drain
clamp is facing towards the drinking water faucet .
B) Using the fitting hole of the drain clamp as a guide, drill a
1/4" hole through one side of the drainpipe .
C) Remove the drain clamp from the drainpipe and enlarge the hole
with a 3/8" drill bit. Use a file to remove rough edges from the
Notch For Faucet
drilled hole .
D) Make sure the black rubber gasket is adhered to the inside of
the drain clamp and place the drain clamp assembly over the
drilled hole . Look through the hole and position the clamp so that
the center of the clamp hole is slightly higher (about 1/16") than
Blades Must Be Held
the center of the drilled hole . (See Figure 9) . Tighten the clamp
When Tightening
securely .
E) Screw the plastic compression nut onto the drain clamp until
hand-tight .
G
F
A
Figure 7
B
Figure 8
D
Figure 9
6"
C
E
• 5 •