TierTime UP BOX Mode D'emploi page 35

Problems
Printing or platform cannot
reach target temp or over
heat.
Cannot extrude plastic
Cannot detect the printer
Others
Troubleshooting
1.Initialize the printer.
2.Heater catridge is broken, seek replacement.
3. Cable is broken, replace the cable.
1. Withdraw filament from print head, cut off the
melted tip and reload it to the print head.
2. Plastic clog the nozzle, replace new nozzle or remove
the clog.
3. The filament is too thick. Usually happens when
using filament with poor quality. Please use UP Fila
filament.
4. For some model, if PLA consistently cause problem,
switch to ABS.
1. Install the printer driver correctly.
2. Check for defective USB cable.
3. Restart printer and Computer
Contact technical support:
support@tiertime.net
33
Solution