Publicité
Les langues disponibles
Les langues disponibles
Remove the nozzle.
After a long time of printing, the nozzle could become very dirty or even clogged. We can
replace it with a new one while the old one could be cleaned and reused.
1. Use "Withdraw" function in the maintenance panel, nozzle will heat up to printing
temperature.
2. Wear heat resistance gloves provided.
3. Wipe the nozzle with tissue or cotton.
4. Unscrew the nozzle using the wrench provided.
5. Remove the clog: there are many method such as drill through the clog using a 0.4mm
drill bit, submerge in acetone or using a heat gun to melt and blow away the clog.
Replace the Air Filter
Turn clockwise to install
the cap.
Turn anti-clockwise to
remove the cap.
Maintenance
Nozzle Wrench
27
Filter Catridge
Publicité
