Publicité
Les langues disponibles
Les langues disponibles
Hit the "5" button. Nozzle will go
to the center of the platform.
4
Raise the platform until it is
just touching the nozzle. Move
the paper between the nozzle
and platform and see if there
is any resistance.
Platform too high, nozzle
is pinning paper onto
the platform, Lower the
platfrom slightly.
When obtained the right platform
height, write down the value of "current
height".
We will refer this as the "Platform
Height Value".
R epea t st ep 1- 6 f or all other 8
positions and obtain their platfor m
height values.
6
Just right, could feel
s o m e r e s i s t a n c e
when mo ving the
paper.
30
Platform too low, no
resistance at all when
moving paper, raise
the platform slightly.
Publicité
