Genesis GD38B Manuel D'utilisation page 9

OPERATIOn
WARnIng:
voltage on the rating name plate.
WARnIng:
unplugged before adjusting, adding accessories, or checking a function on
the tool.
TRIGGER SWITCH ACTION
WARnIng:
tool is switched off.
your tool is equipped with a variable speed trigger switch. The tool speed is controlled by the amount
of pressure you apply to the switch trigger.
• Turn the drill on by depressing the trigger switch.
• Depressing the switch further will produce more speed and torque.
• use the reversing switch (3-fIG 1) to change the direction of rotation of the drill. Always check the
rotation before beginning your work.
LOCK-ON BUTTON
The "Lock-On" button (5-fIG 1) is located in the handle of your tool, beside the switch trigger and
allows you to continuously operate the drill at a preset RPM without holding down the switch trigger.
To lock the trigger "ON", pull the switch trigger back fully, depress the "Lock-On" button and
release the trigger.
To unlock the trigger, squeeze the trigger back completely then release it without depressing the
"Lock-On" button.
KEYLESS CHUCK
WARnIng:
before adjusting, adding accessories, or checking a function on the tool.
your drill is equipped with a keyless chuck to allow for easy installation and removal of drill bits and
accessory items. Keyless chucks eliminate the need for special tools to loosen or tighten the chuck
jaws. using the keyless chuck involves manipulating two chuck components: the collar, a narrow ring
located at the base of the chuck and the chuck body, the larger portion where the drill bit is inserted.
To tighten the chuck, grasp the collar with one hand then rotate the chuck body with the other
hand in a clockwise direction. To loosen the chuck, rotate the chuck body in a counterclockwise
direction while holding the collar in place with the other hand.
To install a drill bit, unplug your drill, and open the chuck jaws to a point where the opening is
just large enough for the bit you intend on using. Point the drill/chuck upwards (to prevent the bit
from falling out) and insert the bit into the chuck the full length of the jaws. Now tighten the chuck by
grasping the collar with one hand and rotate the chuck body clockwise with the other hand until the
chuck is securely holding the bit.
WARnIng:
broken.
Always check that the power supply corresponds to the
Always be sure that the tool is switched off and
Before plugging in the tool, always check to see that the
Always be sure that the tool is switched off and unplugged
never attempt to operate a bit that is wobbly, unstable, or
9