3.
Plug the hot melt glue gun into a mains socket.
4.
Insert the glue stick into the rear hole of the glue gun. Press the trigger several times
until the bar is firmly engaged in the heating mechanism.
5.
Wait between 5 to 8 minutes for the glue to warm up. Then squeeze the trigger until
the melted glue starts to come out of the nozzle.
6.
If the glue stick is used up, you can insert another glue stick without any difficulties.
Don't worry about residual glue inside the gun; it will cool down and re-melt on the
next use.
7.
When you have finished using the gun, unplug it and allow it to cool before storing it.
Warning
1.
This glue gun works by using high temperatures to melt the glue sticks, so the nozzle
and the melted glue is extremely hot (up to 200 ºC).
2.
Never touch the nozzle while the gun is in use or immediately after unplugging it, as
it will keep hot for several minutes.
3.
Never touch the molten glue emitted by the glue gun until it has cooled down
completely.
4.
Be extremely careful when using this appliance, otherwise you may get burned.
4. CLEANING AND MAINTENANCE
Maintenance
While the appliance is not being used, you must store it following these instructions:
-
The room temperature must be lower than 40 ºC.
-
It must be dry, moisture-free and protected from cold and heat.
-
You must store it in a place protected from dust and direct sunlight.
Maintenance indications
Inside the appliance there are not any pieces the user must maintain or lubricate.
Pre-maintenance works
Warning due to electrical voltage
Only the official Cecotec Technical Support Service or specialised or authorised companies can
carry out maintenance operations and repairs that involve opening the housing.
Cleaning
It is necessary to clean the device before and after using it.
-
To clean the external parts of the device, use a clean, soft, lint-free cloth, it may be slightly
moistened. Make sure moisture does not enter the casing or come into contact with any
electric component.
PERFECT FIX 20 + PERFECT FIX 100 PRO
ENGLISH
43