To Set A Delay For Patrol 1; Spare Outputs; Maximum Number Of Cameras - Dedicated Micros Dennard DTX1000 Manuel D'installation

To set a delay for Patrol 1.

Press the set button to access the menu and then press CAMERA SELECT 7 button (to set a delay
time in Patrol 1.) followed by the appropriate CAMERA SELECT button to give the required delay
time.
SET PATROL 1
DELAY
To set a delay for Patrol 2.
Press the set button to access the menu and then press CAMERA SELECT 8 button (to set a delay
time in Patrol 2.) followed by the appropriate CAMERA SELECT button to give the required delay
time.
SET PATROL 2
DELAY

Spare Outputs

There are four spare outputs, with momentary action, for use as relay drivers. To activate these
outputs press and hold shift whilst pressing one of the auxiliary buttons. An on screen display
confirms which output has been activated. Advanced receiver functions are controlled using the
spare outputs.See the relevant receiver handbook.
SPARE OUTPUT

Maximum number of cameras

This option sets the number of cameras on the system.
Operate the set button to display the menu.
Press the CAMERA SELECT 15 button to call the menu option 15 (maximum number of cameras)
and the screen will display: MAX CAM SELECT?
Operate the CAMERA SELECT button which corresponds to the number of cameras on the system.
The system is now programmed and will return to normal operation.
SET MAXIMUM NUMBER
OF CAMERAS
Dennard DTX1000 Installation Manual
then:
to select
option 7
(set patrol 1 delay)
then:
to select
option 6
(set patrol 2 delay)
then up to
then up to
Any auxiliary button
and
then then
up to
Page. 11