Patrol Settings; To Programme A Patrol; To Remove A Preset From A Patrol; To Programme A Time Period For A Patrol - Dedicated Micros Dennard DTX1000 Manuel D'installation

Patrol Settings

There are two patrol programmes that can be activated by the Dennard dtx1000. This is achieved
by pressing the Patrol button and either CAMERA SELECT button 1 or 2. All other keys are
ignored. The patrol function is to enable a string of presets to be selected in turn, switching
between them after a fixed period of time (nominally 30 seconds)
Note: Once the factory setting of 30 seconds has been altered to some other value, that particular
setting cannot be recovered.
Patrols can be stopped at any time by pressing any of the four arrows on the pan & tilt control, after
selecting the receiver on which the patrol is running.

To Programme a Patrol

There is no separate patrol programming function with the Dennard dtx1000 keyboard. Once a
preset has been programmed it is automatically included in patrols 1 & 2.

To Remove a Preset from a Patrol

Select the camera/receiver on which the patrol is to run by pressing appropriate CAMERA SELECT
button. Press the set button to access the menu and then press CAMERA SELECT 5 button (to
remove a preset from patrol. 1) or 6 (to remove a preset from patrol. 2) followed by the preset
number to be removed by pressing the appropriate CAMERA SELECT button.
REMOVE
PRESET
then
to remove
patrol 1
preset
To Program a Time Period for a Patrol
First determine the time delay required from the following table of CAMERA SELECT button
numbers:
Button 1 Random
Button 2
Button 3
Button 4
Button 5
Button 6
Button 7
Button 8
Dennard DTX1000 Installation Manual
up to
or
to remove
patrol 2
preset
0 to 100 seconds
12 seconds
24 seconds
36 seconds
48 seconds
60 seconds
72 seconds
84 seconds
then for menu option
then up to
Button 9
Button 10
Button 11
Button 12
Button 13
Button 14
Button 15
Button 16
96 seconds
108 seconds
120 seconds
132 seconds
144 seconds
156 seconds
168 seconds
180 seconds
Page. 10