Preset (Select, Programme & Erase) - Dedicated Micros Dennard DTX1000 Manuel D'installation

The remainder of this handbook refers to features found only on the Dennard drx100/ 400 /400dc
receivers.
Presets (select, programme and erase)
To select an existing preset, press the preset button. The monitor will display PRESET. While
holding down the preset button select the desired preset number.
PRESET SELECT
up to
then
To programme a preset, first select the desired camera by using the CAMERA SELECT buttons.
Position the camera using the Up Down Left Right arrows, then set the ZOOM and FOCUS. When
you are satisfied with the position and quality of the picture, press the set button to display the
Menu.To call menu option 1 (preset) operate the CAMERA SELECT 1 button. When the menu
changes to PROGRAM PRESET enter the number of the preset you have just programmed using
the CAMERA SELECT buttons.
PROGRAM PRESET
up to
and
up to
then
then then
select option 1
(preset)
To erase a preset, press the set button to gain access to the menu. Select option 4 and when the
display changes to ERASE PRESET, select the number of the preset to be erased
ERASE
then
up to
then
select option 4
PRESET
(erase preset)
Dennard DTX1000 Installation Manual Page. 9