Publicité
engine. One or two pulls usually starts the engine.
6. Move the choke control lever (if used for cold engine), slowly back to the "RUN" position when
the engine is running well.
7. If the machine has not been running (cold engine), warm up the engine by running it at half
throttle for 3 to 4 minutes, then advance the engine throttle control to the maximum speed.
STOPPING YOUR EQUIPMENT
1. Move the throttle lever to "IDLE".
2. Slide the gas lever to the left to shut the engine off.
MAINTENANCE
Regular maintenance is the best way to ensure optimal performance and longevity of the machine.
Please refer to this User Manual and engine manufacturer's User Manual for maintenance
procedures.
WARNING! BEFORE PERFORMING ANY MAINTENANCE OR INSPECTION: Stop the
engine, wait 5 minutes to allow all parts to cool. Disconnect the spark plug wire, keeping it
away from the spark plug. Disconnect the battery terminals.
REGULAR MAINTENANCE CHECKLIST
PROCEDURE
Check engine oil level
Check general equipment condition
Check blades and bolts
Check belt
Check tire pressure
Check engine exterior and recoil cover
Check engine oil
Replace air filter
Replace spark plug
1 2 3 4
LEGEND
BEFORE EACH USE
1
EVERY 3 HOURS
2
EVERY 25 HOURS
3
EVERY 100 HOURS
4
v.220704 | 27
Publicité
