Nordpeis N-27 Manuel D'utilisation page 20

Self-closing hatch
The insert can be supplied with a self-closing hatch. First open the hatch according to section "Cleaning the hatch
glass", then remove the four screws to release the Upper member. Remove the two screws that hold the spring
assembly, install the weight to the upper member and reinstall the spring assembly in the upper screw holes.
Reinstall the Upper member using the four screws. The insert can now be supplied with the self-closing hatch.
Spring assembly
Upper member
Weight
Installing removable parts 2
Removing the hatch from the insert facilitates the
installation of the hearth surround on the N-30. If the
insert is recessed, removal of the hatch is made easier
if the damper knob is removed. After the catches have
been opened the hatch will fall forward to a limit posi-
1
tion. Now lift the hatch and at the same time move it to
the left so that the right side releases from its moun-
ting, then tilt the hatch out. Assembly takes place in the
reverse order.
20
GB