Installation And Connection; Operation - Cookmax Ak220Em Mode D'emploi

on the Refrigerated showcase and do not expose the device to rain water, dripping water
or any other kind of moisture. The device can cause injuries due to improper installation!
Before installation the local power grid specification should be compared with that of the
device (see type label). Connect the device only in case of compliance! Take note of the
security advice!
• See that the cable does not touch any heat sources or sharp edges.
• Do not use the device in case it does not function properly, has been damaged or
dropped.
• Do not use any accessory or spare parts that have not been recommended by the
manufacturer. These can be dangerous for the user or lead to damages of the device or
personal injury, and further, the warranty expires.
• Do not lay the cable over carpets or heat insulations. Do not cover the cable. Keep away
the cable from operating range and do not dunk it into water.

Installation and connection

• Discard the complete packing material after unpacking the device.
• Place the device on top of an even and safe surface which supports the weight of the
device.
• Never at any time place the device on an flammable surface (such as: carpet, etc.).
• Do not place the device near the open fire sources, electric ovens, heating stoves or
other heat sources, for example direct sunlight. Exposition to high temperatures may
cause damage to the device surface or may negatively influence cooling power and
energy consumption.
• In order to avoid failures of the compressor when assembling or transporting the
refrigerated showcase, it should not be tilted over an angle of 45° at any time. Always
use condenser and glass side wall with care as damages affect the optimal use.
• Set up the refrigerated showcase at an ample place, where a proper air circulation is
possible. A minimum distance of 5 cm must be kept to walls and other items.
• Do not set up the refrigerated showcase at places with high humidity or high
temperatures, as these effects may damage the device.
• For the first time use, wait for 2 hours after handling and then plug the wall socket and
start it.
• Never punch holes into the refrigerated showcase. Never install foreign matters/
substances on the Refrigerated showcase.
• Never put any heavy load on the top of the refrigerated showcase.
• Position the device in a way so that the power plug is always accessible.

Operation

• Clean the device prior to first use.
• Wash the grids in warm water and mild cleaning agent prior to placing them inside the
refrigerated showcase (only AK200EM).
19
- 19 -