To stop the product
1. Move the ON/OFF switch to the OFF position (if
equipped).
2. Remove the ON/OFF key.
To use the throttle control
•
Slide the throttle control (A) to change the
amount of fuel used. Always operate the engine
at full throttle.
A
To use the fuel switch
•
Slide the fuel switch (A) to open or close the fuel
valve. Operate the product with the fuel switch in
the OPEN position.
A
14
To use the choke control
•
Slide the choke (A) to open or close the choke
valve. Use the choke to start a cold engine.
A
To adjust the skid plates
The skid plates prevent damage to the bottom of the
snow thrower. Adjust the skid plates (A) when the
locknut (B) is loose, or the skid plate is not at the
correct distance from the ground. No adjustment is
necessary for standard installation.
1. Loosen the locknut (B) with a 13 mm (½ in.) open
wrench.
2. Move the skid plates (A) up or down.
a) On flat surfaces set the distance between the
scraper bar and the ground to 5-6 mm
(0.2-0.25 in).
b) On rough surfaces set the skid plates (A) in a
position where the scraper bar is above the
top of the ground.
WARNING:
gravel and stones do not go into
the product. Objects that eject at
high speed can cause injury.
3. Tighten the locknut (B).
Make sure that
A
B
1481 - 005 - 18.05.2021