LENCO MC-250 Mode D'emploi page 23

Turn the navigation knob on the unit or press the
select the preset/storing position, press the OK knob on the unit or press the OK button on
the remote control to confirm preset/storing.
Repeat the above steps to store/preset up to 10 stations.
--------------------------------------------------------
FM radio mode
FM radio mode receives analogue radio from the FM band and displays RDS (Radio Data
System) information about the station and show (where broadcast). To enter FM Radio mode,
either press Mode to cycle through the listening modes until FM Radio is displayed, or select
Menu > Main menu > FM. The FM radio mode menu offers the following options:
⚫
Scan Settings
⚫
Audio Settings
⚫
System Settings
⚫
Main Menu
Selecting stations
To find a station, press OK. The frequency display starts to run up as radio scans the FM band.
Alternatively, you can scan up or down by pressing and holding left or right buttons or tune
manually with quick presses.
Note: Scanning can be set to search for strong signals only. Preset stations can be stored and
recalled as described in Presets.
Now playing information
While a FM station is playing, the screen shows one of the two following sets data:
⚫
If RDS information is available, by default the service name (i.e. station name) is
displayed. You can cycle through further RDS information by pressing Info. Each time
you press Info, another set of information is displayed, cycling through RDS radio text,
RDS programme type, frequency and today's date.
⚫
If no RDS information is available, the currently tuned frequency is shown.
or buttons on the remote control to
23