LENCO MC-250 Mode D'emploi page 15

If "Pin" is selected,
the unit generates an 8-digit code number which you have to enter in your wireless
router/accesspoint configuration menu. (check the manual of your router if you need help)
When "Skip WPS" is selected, the below page will appear. Enter your WIFI network passkey
Turn the navigation knob on the unit or use the navigation buttons on the remote control to
highlight the character needed, press the 'OK' button on the unit or remote control to
continue to the next character and repeat the above to complete your WIFI password
BKSP = delete the last entered character
OK = confirm the password
CANCEL = cancel entering the password
After completing the correct password, select the OK on the display and press the 'OK'
button on the remote control to continue.
NOTE: You can also use the number buttons on the remote control to enter the WIFI
password.
Main Menu
After setup is completed, the unit will enter the main menu. The following page will appear.
Turn the navigation knob on the unit or press the or button on the remote control to
navigate through the items in main menu list.
15