LENCO MC-250 Mode D'emploi page 21

Press the button to Pause/Play
Turn the navigation knob on front panel or press the
to skip to previous or next track.
Press and hold the
DAB radio mode
The DAB radio mode receives DAB/DAB+ digital radio and displays information about the
station, stream and track playing. To enter DAB mode, either press Mode to cycle through
the listening modes until DAB Radio is displayed, or select Menu > Main menu > DAB. The
DAB radio mode menu offers the following options:
⚫
Station list
⚫
Scan
⚫
Manual tune
⚫
Prune invalid
⚫
DRC
⚫
Station order
⚫
System settings
⚫
Main Menu
Station List
The first time you select DAB radio mode, or if the station list is empty, radio automatically
performs a full scan to see what stations are available. You may also need to start a scan
manually to update the list of stations for one of the following reasons:
⚫
Available stations change from time to time
⚫
If reception was not good for the original scan (for example the antenna was not up),
this may result in an empty or incomplete list of available stations.
⚫
If you have poor reception of some stations (burbling), you may wish to list only stations
with good signal strength.
A question mark before a station in a list indicates that station is currently unavailable.
Depending on the cause of the loss of signal this may be only temporary. Stations that
unlikely to be available again (for example you have moved out of the broadcast range of a
station), can be removed from the station list.
Scan for stations
To start a scan manually, select Menu > Scan. Once the scan is complete, the radio shows a
list of available stations. The manual tune menu option allows the user to select a particular
channel and display the signal strength for that channel.
Remove stations from list
To remove stations that a listed but unavailable, select Menu > Prune invalid.
Selecting stations
or button to back- or fastward.
I buttons on the remote control
21