Counting; Set The Average Piece Weight (Apw) - Ohaus Defender 5000 Manuel D'instructions

EN-40
The Weighing sub-menu is now displayed.
Select the list item and press the button
corresponding to the icon
setting as desired. After completion of I/O's
setup, press the Softkey corresponding to the
icon
screen.

4.2 Counting

Use this application to count samples of uniform weight.
Press
corresponding to Counting is displayed in the
screen.
The default (or last) Average Piece Weight (APW) is
displayed.
Set the APW value according to section 4.2.1 and
then place objects on the pan to display the number
of pieces.

4.2.1 Set the Average Piece Weight (APW)

Note: It is recommended that the APW is larger than 1d. If APW is between 0.05d and 1d, a warning
message will be displayed and the information line will show 'APW is too small!'. If APW is less than
0.05d, an error message will appear and the APW value cannot be stored.
There are two methods to set the APW:
NOTE: APW Auto-Optimization is automatically disabled if the APW is entered manually or scanned
from a label.
1. Entering a Known APW
Method 1
Key in the Piece Weight using the alphanumerical
keypad.
Then press the Softkey corresponding to the icon
Method 2
Alternatively, first press the Softkey corresponding
to the icon
setting the APW.
Find Quality Products Online at:
to change the
to return to the main application
the button until
.
to enter the sub-menu for
GlobalTestSupply
www.
the icon
.com
Defender 5000 Indicators
sales@GlobalTestSupply.com