Fracarro SAF-HD 10 Notice D'utilisation page 21

USB: USB plug for pen drive connection and for copying/saving the headend unit configuration;
RJ45:
RJ45 jack for PC programmation and for firmware upgrade;
Power LED: ON (green) when the product is fed;
Status LED: shows that the headend unit is working;
ON: normal operation;
FLASHING: unit in boot or updating phase.
UHF3
2.2 FLEXIBLE MATRIX OF FILTERS
The filters can be associated with the 3 UHF1, UHF2 or UHF3 inputs by means of a flexible matrix. The as-
sociation of the filters to the UHF input that you desire is made during the programming phase either from
the keyboard or by the FHM programming software.
The matrix of SAF-HD 10 is defined as follows:
UHF 1
FILTRO FILTRO
1 2
• All selective filters can be associated to the UHF3 input;
• The first 6 selective filters can be associated to the UHF2 input;
• The first 3 selective filters can be associated to the UHF1 input;
• The B.III/DAB/FM input is independent with separate regulations of the gains.
The 10 selective programmable filters can receive the signals from the 3 inputs in a completely flexible way.
All possible combinations can be set (for example, 1 channel from antenna 1, 3 from antenna 2 and 6 from
antenna 3, or 10 channels from the same antenna) by connecting the antenna with the highest number of
channels to be filtered to Input 3 and the antenna with the lowest number of channels to be filtered to Input 1.
UHF2
UHF 2
FILTRO FILTRO FILTRO
3 4 5
Fig. 2.1 - Division of filters in the SAF-HD 10 model
LED to show remote power supply. When
the LED is ON (red), it means that the power
(12V) is activated for that input.
UHF1
UHF 3
FILTRO FILTRO FILTRO
6 7
21
FM
FILTRO FILTRO
8 9 10
OUT RF
TEST RF
FM
B.III
DAB
B.III
DAB