To Clean The Product - Husqvarna ST 124 Manuel D'utilisation

2. Attach a new shear pin (A) and a new clamp spring
(B).
B
To examine the tires
• Keep the tires free of fuel, oil and chemicals to
prevent damage to the rubber.
• Keep the tires away from stumps, stones, ruts, sharp
objects and other objects which can cause damage
to the tires.
• Keep the tire pressure correct, see
on page 19 .
16
A
Technical data
To clear a clogged discharge chute
deflector
Do not unclog the discharge chute deflector before the
following operations are made.
1. Release the auger engagement and the drive
engagement at the same time.
2. Wait 10 seconds to make sure that the augers have
stopped.
3. Stop the product.
4. Use the tool for cleaning (at least 37 cm (15 in.) long,
included in some models) to remove the clog.
WARNING: Do not put your hands into
the discharge chute deflector or inside
the auger bucket.

To clean the product

• Clean plastic parts with a clean and dry cloth.
• Do not use a high pressure washer to clean the
product.
• Do not flush water directly on the motor.
• Use a brush to remove leaves, grass and dirt.
1272 - 003 - 09.08.2019