To Operate The Product; To Stop The Product - Husqvarna ST 124 Manuel D'utilisation

To operate the product

1. Squeeze the auger engagement to the handle to
engage the auger and throw snow.
2. Move the drive speed control lever to the left to
operate the product forward. Move the drive speed
control lever to the right to operate the product
rearward.
3. Operate the drive engagement with the right handle.
4. Squeeze the drive engagement to the handle to
engage the drive wheels. The product moves
forward or reverse depending on the location of the
drive speed control lever.

To stop the product

Note: To turn the engine off in an emergency, pull out
the on/off key.
1272 - 003 - 09.08.2019
1. Release the drive engagement to stop the drive
wheels.
2. Release the auger engagement to disengage the
auger and stop throwing snow.
3. Turn the fuel switch to the OFF position.
4. Pull out the on/off key.
To get a good result
• Always run the engine at full throttle or near full
throttle.
• Always adapt the speed of the product to the snow
situation and adjust the speed with the drive speed
control lever. Make sure that the product throws
snow evenly.
• It is easier and more efficient to remove snow
immediately after it falls.
• Always throw snow downwind whenever possible.
13