Husqvarna ST 124 Manuel D'utilisation page 12

3. Turn the choke to the CLOSE position.
4. Push in the on/off key to the RUN position.
5. Push the primer 1-3 times to start the booster pump.
Use the booster pump for cold start in low
temperatures.
12
6. Connect the product to power.
7. Press and hold the start button on the control box for
5 seconds.
8. If the engine does not start, wait 5 seconds, then
push the start button again.
CAUTION: Do not try to start the engine
more than 10 times. After 10 times, wait
40 minutes before you try again.
9. Run the engine 30-40 seconds at idling speed before
you start to throw snow.
10. When the engine is warm, slowly move the choke to
the OPEN position.
1272 - 003 - 09.08.2019