Adjusting Refrigerator Panel(S) - Jenn-Air JB36NXFXLE Instructions D'installation

INSTALLATION

ADJUSTING REFRIGERATOR PANEL(S)

APPLIES TO:
1.
Slightly loosen the panel bracket screws to allow
the panel to move to the left or right.
2.
Adjust panels to achieve a 1/8"
between panels and adjacent cabinets.
French door bottom mount and bottom mount
models, align the outside edge of the refrigerator
1
panel to the outside edge of the freezer panel
on both the sides. For side by side models, align
the refrigerator and freezer panels with adjacent
cabinets.
NOTE: Adjust the panel not the door, if
adjustments are needed to achieve alignment or
required spacing.
3.
Tighten the
2
1/8"
3
(3.2 mm) gap
For
panel bracket screws.
INSTALLATION | 23