Troubleshooting - Nilfisk Advance IV 022 Mode D'emploi

INSTRUCTIONS FOR USE

TROUBLESHOOTING

Fault
The vacuum suddenly Clogged primary filter
stops
Motor protector tripper Clogged suction pipe
Dust leaks from the The filter is torn
vacuum
Inadequate filter
The vacuum blows Incorrect connections to
instead of sucking the mains socket
Electrostatic current on Non existent or
the vacuum inefficient earthing
14
Causes Remedies
Shake the filter. Replace
it if this is not sufficient
Check the setting.
Check the suction pipe
and clean it.
Check the power draw of
the motor. Contact an
authorized after-sales
service centre if
necessary
Change it for another of
identical category.
Change it for another of
suitable category and
check.
Check all earth
connections. Particularly
check the suction inlet
fitting.
Remove the plug and
invert two of the live
wires.
Lastly, the pipe must
strictly antistatic
32401105(1)2004-04 A