Important Safety Instructions; Unpacking; Specifications - Haussmann FSN50 Manuel D'utilisation

IMPORTANT SAFETY INSTRUCTIONS

16. DO NOT LOAD FASTENERS with the trigger depressed. The tool may
unintentionally fire a fastener.
17. DO NOT DEPRESS THE TRIGGER when not driving fasteners. Never carry
tool while touching on the trigger mechanism: tool may fire an unwanted
fastener.
18. DON'T OVERREACH. Keep proper footing and balance at all times. Do not
reach over or across machines which are running.
19. GRIP TOOL FIRMLY to maintain control while allowing the tool to recoil away
from the work surface as the fastener is driven.
20. DO NOT DRIVE NAILS on top of other fasteners, or with the tool at too steep
an angle: the fasteners can ricochet causing personal injury.
21. FIRE FASTENERS INTO WORK SURFACE ONLY. Do not drive nails nor
attempt to do so, into hard or brittle materials such as steel, concrete, or tile.
22. DO NOT DRIVE NAILS too close to the edge of the workpiece. The workpiece
is likely to split, allowing the fasteners to fly free or ricochet causing personal
injury.
23. STAY ALERT. Keep hands and body away from the path of any potential fired
fastener. Watch what you are doing & use common sense. Don't operate
any tool when you are tired or under the influence of drugs or alcohol. Check
prescriptions to determine if there could be a problem.
24. PREVENT ELECTRIC SHOCKS. Prevent body contact with grounded
surfaces: pipes, radiators, ranges, and refrigerator enclosures. Before
driving fasteners into walls, floors, or wherever "live" electrical wires may be
encountered, check whether there is a danger of shock.
25. KEEP WORK AREA CLEAR of obstructions.
26. STORE IDLE EQUIPMENT. When the tool is not being used, it should be
cleaned, and stored in a clean dry place out of the reach of children.
27. USERS must follow all safety warnings and other instructions in this manual.
Keep it available for use by everyone assigned to use this tool.
WARNING! The warnings, cautions, and instructions detailed in this manual
cannot cover all possible conditions and situations that occur. It must be
understood by the operator that COMMON SENSE AND CAUTION ARE
FACTORS that cannot be built into this product, but MUST BE SUPPLIED BY
THE OPERATOR.

UNPACKING

Check immediately that all parts and accessories are included. If anything is
missing or broken, contact Customer Service at 1 (866) 599-5916 ext.2.
z Hammer
z Nailer / Stapler
z S3, S4, & S5 hex keys
z 25/32" (19.8 mm) spacer (installed)
z 1/2" (12.7 mm) spacer
z Air tool oil
z Operator's manual

SPECIFICATIONS

z Shoots standard flooring cleat nails minimum 1-1/2" (38 mm) long to a
maximum length of 2" (51 mm)
z Shoots standard 15-1/2 ga. 1/2" (12.7 mm) crown flooring staples minimum
3/4" (19 mm) long to a maximum length of 2" (51 mm)
z Operating pressure: 60-100 PSI
max. 120 PSI
z Air consumption: 5 CFM @ 80 PSI
z Nail capacity: 100
z Staple capacity: 80
z Air inlet: 1/4" NPT
z Tool weight: 11.5 lbs (5.2 kg)
14
!