JB Systems High Q10 Mode D'emploi page 5

CONNECTIONS
Connect the power cord to a wall AC outlet.
•
Connect the unit's output terminals to the PHONO jack of your
•
mixer our amplifier (do not use a line input as this leads to
insufficient signal level and non-linear frequency response).
Connect the GND lead firmly to the GND screw on the mixer or
•
amplifier. When this connection is not made, unnecessary hum
or noise will occur.
OPERATION
Select the speed required for the record that you want to play.
•
Put the record on the turntable. Use the puck if needed
•
(e.g. for 45").
Remove the stylus cover and release the tone arm.
•
Set the tone arm lift to the up position and move the tone arm
•
to the desired starting position. When there is not enough
light, use the target light for spotting the exact starting
position.
Set the tone arm lift to the down position; the tone arml slowly
•
lowers to the record.
When the record has finished playing, move the tone arm lift
•
to the up position and put the tone arm in rest position
(down).
5 High Q10