Beko RDNG491M20SXB Manuel D'utilisation page 7

Instructions for safety and environment
When placing the product, make sure
that the supply cable is not damaged
or pinched.
The product must not be connected
to supply systems such as solar
power supply. Otherwise, your
product may be damaged due to
sudden voltage changes!
The more refrigerant a refrigerator
contains, the bigger its installation
room should be. In very small rooms,
a flammable gas-air mixture may
occur in case of a gas leak in the
cooling system. At least 1 m3 of
volume is required for each 8 grams
of refrigerant. The amount of the
refrigerant available in your product is
specified in the Type Label.
The installation place of the product
shall not be exposed to direct sunlight
and it shall not be in the vicinity of a
heat source such as stoves, radiators,
etc. If you cannot prevent installation
of the product in the vicinity of a heat
source, use a suitable insulation plate
and make sure the minimum distance
to the heat source is as specified
below:
– At least 30 cm away from heat
sources such as stoves, ovens,
heating units and heaters, etc.,
– And at least 5 cm away from
electrical ovens.
Your product has the protection class
of I.
Plug the product in a grounded socket
that conforms with the Voltage,
Current and Frequency values
specified in the type label. The socket
must have a 10A – 16A fuse. Our firm
will not assume responsibility for
any damages due to usage without
earthing and without power
connection in compliance with local
and national regulations.
The product's power cable must
be unplugged during installation.
Otherwise, risk of electric shock and
injury may occur!
cord in loose, dislocated, broken,
dirty, oily power outlets which
have a risk of water contact. These
types of connections may cause
overheating and fire.
Place the power cable and hoses
(if any) of the product so that they
shall not cause a risk of tripping
over.
Penetration of humidity and liquid to
live parts or to the power cord may
cause short circuit. Thus, do not use
the product in humid environments
or in areas where water may splash
(e.g. garage, laundry room, etc.) If
the refrigerator is wet by water,
unplug it and contact an authorized
service.
Do not ever connect your
refrigerator to power saving
devices. These systems are harmful
for the product.
There is a risk of contact with
electrical parts when removing
the electronic board cover and the
compressor rear cover (if fitted).
Do not remove the electronic board
cover and the compressor rear
cover (if fitted). There is a risk of
electrocution!
6 / 30 EN
Refrigerator / User Manual