Programming In Auto Mode; Service Mode - Seeley LCQ Manuel Du Propriétaire

MAGIQCOOL CONTROLLER
OPERATION cont.

Programming In Auto Mode

(1)...... Press the
(2)...... Press the
displayed.
(3)...... Press the
in' time will start flashing.
Use the or
the hour.
(4)...... Press again.
The delayed stop time can only be
programmed once the cooler is ON. This is
ideal if you are going to bed but don't want to
turn the cooler off straight away. To program
the delayed time in which you want the cooler
to stop use the following sequence:
(1)......Select the
in' time will start flashing.
Use the and
the desired off time.
(2)......Press again.
|
4
INTERNATIONAL
button.
button until AUTO is
button and the 'starts
button to select
ILL1117-B
button and the 'stops
buttons to select
ILL1119-B

Service Mode

When a fault has been recognised by the wall
control the word "Service" flashes on the
screen.
Service
When "Service" is displayed it may be
necessary for you to phone the service number
located near the back of this manual. However,
before doing so, turn the wall control OFF. You
will notice a number flashing at the bottom of
the screen. This number indicates the reason
for requiring service.
Service
Please write this number down, then push
the button to turn the cooler back on.
If after a short time "Service" is again shown
on the display, turn the wall control OFF and
check if the flashing number is the same. If it
is the same check for the following possible
problems.
However, we do recommend that any checks
be carried out by an authorised dealer or
service agent.
ILL1120-B
ILL1120-B
ILL1121-B
ILL1121-B