Auto Mode; Delayed Start Or Stop; Programming In Manual Mode - Seeley LCQ Manuel Du Propriétaire

MAGIQCOOL CONTROLLER
OPERATION cont
You may then press the
switch between COOL and VENT (where fresh
air is being delivered but not cooled).
Once COOL or VENT has been selected, the
wall control will maintain a constant fan speed.
This is indicated by the bar graph shown on
the display.
To increase or decrease the fan speed
required, press either the
button.

Auto Mode

To select the AUTO mode press the
button until AUTO is shown on the display.
In AUTO mode the cooler will remember the
last setting used. Press the
you require more cool air or the
if you require less. Don't alter the setting
however, until the room temperature has
stabilised.
MAGIQCOOL CONTROLLER
OPERATION cont

Delayed Start or Stop

button to
The cooler can be programmed to start at a
specific time or stop at a specific time.
The delayed start time can only be
programmed when the cooler is OFF. To
program the cooler to start in a certain amount
of hours use the following sequence:

Programming In Manual Mode

(1)...... Press the
(2)...... Press the
displayed on the screen.
(3)...... Press the
until the desired fan speed is displayed by the
bars in the middle of the screen.
ILL1123-B
or
(4)...... Press the
COOL or VENT.
(5)...... Press the
in' time will start flashing.
Use the
the desired time.
(6)...... Press
ILL1124-A
button if
button
LCQ / LCS / LCQI / BMQ / CPQ / TBQ / TBS / TBQI / TBSI |
button.
button until MAN is
or button
ILL1118-A
button to set either
button and the 'starts
and buttons to select
again.
3