Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
2. Unplug ice maker or disconnect power.
3. Turn off water supply. Wait 5 to 10 minutes for the ice to fall
into the storage bin. Remove all ice from bin.
4. Unscrew the drain cap from the bottom of the water
pan located inside the storage bin. Allow water to drain
completely. Replace drain cap. See "Drain Cap" illustration.
Drain Cap
A
A. Drain cap
5. If ice maker is built into cabinets, pull ice maker out of the
opening.
6. Disconnect water supply line. See "Water Supply Line"
illustration.
Water Supply Line
A. 1/4" (6.35 mm) copper
tubing
B. Cable clamp
C. 1/4" compression nut
Drain Pump Installation
NOTE: Do not kink, smash or damage tubes or wires during
installation.
1. Unplug ice maker or disconnect power.
2. Remove rear panel. See "Rear Panel" illustration for 5 screw
locations. Pull rear panel away from the drain tube and
discard.
Rear Panel
A. Screw locations
6
A
B
B
C
D
C
E
D. Ferrule (sleeve)
E. Ice maker connection
A
A
3. Remove the old drain tube and clamp attached to the ice
maker bin.
NOTE: Discard old drain tube and clamp.
4. Install new drain tube (5/8" I.D. x 5¹⁄
drain pump reservoir inlet using new adjustable clamps. See
"Drain Tube" illustration.
NOTES:
Do not kink.
■
Trim tube length if required.
■
Drain Tube
A. 7/8" adjustable hose clamp
B. Drain tube (ice bin to drain pump)
5. Install vent tube (5/16" I.D. x 32" [81 cm]) to drain pump
reservoir vent. Use one of the supplied 5/8" small adjustable
clamp. See "Parts Locations" illustration.
NOTE: Do not install household drain tube at this time.
Parts Locations
C
G
F
A. Vent tube
B. 5/8" hose clamp
C. Drain pump discharge tube
D. Drain pump
6. Remove power cord clamp and ground screw attached to ice
maker power cord, which is mounted to the unit base. See
"Parts Locations" illustration.
NOTE: Clamp and screw will be reused.
") from ice maker bin to
8
A
B
C
D
C. 7/8" adjustable hose clamp
D. Drain pump reservoir inlet
A
B
D
E
E. Ice maker unit power cord
F. #8-32 x 3/8" pump mounting
screws
G. Drain pump power cord, clamp
and screw
Publicité
Table des Matières
