Volfoni EDGE VR VPEG-05010 Manuel D'utilisation page 9

Advanced :
Delta Sync (μs) : Modify the sync offset (between -2000
and 2000 microseconds). Default = 0
3D Sync :
Choose time of the free wheel to eventually win more
autonomy
Moves sensibility :
Choose the sensibility of the glasses move sensor
Auto-OFF on moves :
Choose time before glasses shut down if there is no
movement
Auto-OFF on sync :
Choose the time before shut down if the glasses doesn't
receive any 3D sync signal
Low level battery :
Choose the treshold that determines that the battery is
low
16
7. TROUBLESHOOTING
PROBLEM
The RF signal is not
recognized.
The glasses are blinking
strongly.
The glasses blink when
I turn them ON
The EDGE™ RF glasses
are not synchronizing
with the ActivHub
TM
RF50
The EDGE™ RF glasses
stay OFF despite the
fact that I press the
ON/OFF button to turn
them ON
SOLUTION
Check that your ActivHub
is emitting RF. The blue LED
on the side of the ActivHub
RF will flash 2 times quickly to
indicate that it is emitting RF.
Check that there is no other
source using the same RF
channel within a range
of 30 meters around the
ActivHub RF.
TM
When this phenomenon
occurs, it means that
the battery is low. Please
recharge the glasses.
Verify that the RF channel
selected under the
ActivHub RF is set to
TM
position "8". Check that
your original source is
broadcasting 3D.
Try recharging your glasses. If
the problem persists, contact
support@volfoni.com
TM
TM
17