Volfoni Loader - Parameters - Volfoni EDGE VR VPEG-05010 Manuel D'utilisation

- connect your computer to the μUSB connector on the
arm of the EDGE VR with the USB/μUSB cable
TM
- press and hold the ON/OFF button of the EDGE
during 3 seconds.
- the LED of the EDGE
TM
- verify that the application recognizes your system
- once you are connected, press the button "Check for
updates"
- download the lastest version

6. VOLFONI LOADER - PARAMETERS

You can access to this part by clicking on "parameter"
in the menu "edit"
14
VR will light red
You must be in "Bootloader Mode" so that the EDGE™
VR is recognized by the software.
VR To do this, once the USB/μUSB cable is connected to
TM
the computer, press and hold the ON/OFF button for 3
seconds.
Switch Pos (A, B or C) :
- 3D : You can bind one of these features on each switch
position:
Inverted / Normal / 2D Left / 2D Right
(if you want to use shared screen you need to set a pair
of glasses on 2D Left and the other on 2D Right)
- Synchronisation : choose between IR and RF
- RF Channel : choose which channels the glasses will
receive on this switch position (you have to choose the
same channel on your ActivHub
Dark Time :
Allows you to change the value of DarkTime
The slider allows you to adjust the value between -4000
microseconds (better luminosity) and 4000 microseconds
(better contrast). The value applied is inscribed above
the slider (0 in this example)
Moves Detection :
Enables or disables the Auto OFF feature when glasses
are not moving
Enabled: The glasses turn OFF automatically if no
movement is detected after 5 minutes (AUTO OFF
enabled).
Disabled: The glasses will stay on even if no motion is
detected. (AUTO OFF function disabled).
RF50)
TM
15