Troubleshooting; Corrective Action - Gaymar Auto Sure-Float C1000MS Manuel De L'opérateur

Auto Sure-Float™
Place no more than four top covers in a single extra large load capacity washing machine. When
wash cycle is complete, remove promptly from machine and ensure all excess water is drained
from load. Place dryer on LOWEST heat setting, or AIR FLUFF if available until dry. Verify top
cover is completely dry before placing under patient.
•
If individual air cells of mattress become soiled, clean and disinfect as described above or simply
replace air cell with a clean replacement. A plug is available from Gaymar to prevent water from
entering air cells during laundering (P/N 30287).
•
The Plexus mattress cover should be inspected for tears, punctures, and excessive wear each
time the cover is cleaned. Compromised covers should be discarded and replaced with a new top
cover and the internal components of the mattress must be cleaned and disinfected using warm
water and a hospital grade disinfectant before being placed back in service.
Do not launder the Claret colored Active Sensor Technology
/M1002S series mattress. Damage may result. If one or more of the Active Sensor
Technology
Control Unit Storage
•
Check the AC power cord and plug for abrasions or excessive wear.
•
Coil power cord up and place both cord and Control Unit in plastic bag for storage.
Air Floatation Mattress Storage
•
Check the air manifold of the mattress for kinks or breaks. Replace if necessary.
•
To deflate, disconnect hose assembly from Control Unit.
•
Coil the hose assembly loosely and roll the deflated mattress starting at the head end. When
rolling up the mattress, use the straps for containment. Place in plastic bag for storage.

14.0 Troubleshooting

Symptom:
Mattress does not inflate or is too
soft.
Other.
®
air cells become damaged, they can only be replaced as a complete set.

Corrective Action

•
Verify the air hoses are not kinked, cracked, or split.
•
Verify the hose couplings are fully engaged to the Control
Unit.
•
Verify the air cells are not damaged.
•
Verify that the Control Unit is ON and that air is coming
from either connector outlet.
•
Verify that all 20 air cells are connected to the air manifold
within the mattress.
See the following Basic Operator Trouble Shooting flow chart.
12
WARNING
®
air cells of the M1001S