DS Produkte Z 09268 Mode D'emploi page 26

12. Wait a few minutes for the device to cool off before you remove the fl oor pad. Be
aware that when turning off the device a wet area can form beneath the clean-
ing head.
13. Follow the instructions in the section "After use".
Use as a handheld steam cleaner
ATTENTION!
■ Risk of injury! Only hold the device by the handle during operation.
■ Let the device, i.e. the nozzle, cool down before changing a nozzle.
■ Always work with suffi cient lighting.
1. Take the handle bar and cleaning head off of the main unit and mount the nozzle
adapter with the desired nozzle on it (see chapter "Assembling the device" and "De-
vice functions (Nozzle functions)").
2. Fill the water tank (see chapter "Filling the water tank").
4. Insert the mains plug in a properly installed socket that is easily accessible. The
power LEDs (12) behind the water tank will illuminate in red as soon as operating
voltage is present. Wait until the device has reached the operating temperature and
the power LEDs are blue.
5. Push the On / Off switch (13) on the back of the main unit and steam begins to be
emitted from the nozzle. You can now increase the quantity of steam by turning the
knob for the steam quantity control. NOTE: After the knob is turned, it will take a few
seconds until the respective steam quantity is reached.
6. Slowly let the nozzle glide over the surface to be cleaned.
7. When the power LEDs blink red, there is too little water in the tank. Push the
On / Off switch and fi ll water in the tank (see chapter "Filling the water tank").
8. Before you change the nozzle or once you have fi nished your work, push the
On / Off switch and pull the mains plug out of the socket. Never pull on the cord, but
always on the plug.
9. Follow the instructions in the section "After use".
After use
1. Turn off the device and pull the mains plug.
2. After every use, take the water tank out of the main unit and empty it into a sink.
3. Let the device and accessories cool off completely.
4. Clean the device and fl oor pad after use as described in the chapter "Cleaning and
care".
27
3. Turn the knob for the steam quantity control (8) to the minimum
setting by turning it counterclockwise until it comes to a stop.
EN