Vorwerk KOBOLD SPB100 Manuel D'utilisation page 66

66
Fault
The DuoClean causes
streaks/marks on the floor.
The DuoClean is not
vacuuming effectively.
Possible cause and solutions
– Check whether the cleaning cloth is straight and firmly
fixed on the cloth holder frame.
– Check whether the green nose of the cleaning cloth has
been correctly and fully pushed in.
The cloth holder frame is not inserted correctly.
– Check whether the cloth holder frame has attached itself
correctly to the DuoClean.
– It is possible that original Kobold cleaning cloths were not
used.
– Only use original Kobold cleaning cloths.
– Use the Kobold MF600/601 Universal cleaning cloth on
rough surfaces.
It is possible that the sealing lip frames are dirty and jammed.
– Remove the front sealing lip frame, see
cleaning the sealing lip frames
It is possible that the cleaning cloth is soiled excessively.
– Change the cleaning cloth, see
cloth [} 61].
It is possible that the sealing lip frames are dirty and jammed.
– Remove and clean the sealing lip frames, see
and cleaning the sealing lip frames
– Also check whether the suction openings between the
sealing lips are clear from underneath. If necessary, shake
out any objects inside.
– Check whether the sealing lip frames are able to move.
The cleaning cloth may be attached to the cloth holder frame
3
at an angle and be obstructing the sealing lip frames.
– Check whether the cleaning cloth is evenly fixed on the
cloth holder frame.
It is possible that the suction channel is blocked.
– Open the inspection flap on the left hand side of the
DuoClean to clear any blockages. This can be done by
inserting a coin into the groove (1).
The magnetic latch on the inspection flap comes open (2).
You can now clearly see inside the suction channel.
– Remove any objects that are blocking the suction channel
(3). To do this, use an appropriate blunt object (e.g.
screwdriver, crochet hook).
Checking and
[} 63].
Replacing the cleaning
Checking
[} 63].