Blade Sharpening - Hkoenig Msx256 Manuel D'instructions

Disassembly of the blade-cover (4).
• Loosen the knob (9) unthread it and
remove the
blade-cover disk (4).
• Clean the blade (3) on both faces as
indicated in the drawing.
If the sliding carriage stops sliding smoothly, lay the
machine on its side.
Cleaning the slide bar (29) and lubricate it with Vaseline
or industrial oil.

BLADE SHARPENING

If the appliance does not slice well and blade is blunt,
blade should be sharpened by qualified staff.
N.B.: it should be noted that the blade is highly resistant,
therefore it needs to be sharpened only when the
capacity of cut decreases. The gauge plate or guard
plate shall be closed on slicers with an integral blade
sharpener during the sharpening operation.
• Unplug.