Hkoenig MSX254 Manuel D'utilisation page 9

could be cleaned in all its parts without having to
disassemble it.
• Use anticutting gloves.
Disassembly of the blade-cover (4).
• Loosen the knob (9) unthread it and remove the
blade-cover disk (4).
• Clean the blade (3) on both faces as indicated in the
drawing.
If the sliding carriage stops sliding smoothly, lay the
machine on its side.
Cleaning the slide bar (29) and lubricate it with Vaseline
or industrial oil.
BLADE SHARPENING
If the appliance does not slice well and blade is blunt, blade
should be sharpened by qualified staff.
N.B.: it should be noted that the blade is highly resistant,
therefore it needs to be sharpened only when the capacity of
cut decreases. The gauge plate or guard plate shall be closed
on slicers with an integral blade sharpener during the
sharpening operation.