Inspection And Cleaning - WAGNER Painteater Guide D'utilisation

ChanGinG the diSC
The disc on the PAINTEATER™ will wear out over time and will need to be changed. You can
find new discs at the original retailer where you purchased the PAINTEATER™, or by calling
customer service at 1-800-727-4023 and ordering replacement discs (part number 0513041).
to change discs, follow the instructions below.
1. Make sure the unit is turned OFF (O) and unplugged. Press the disc lock on the bottom of
the unit and unscrew the disc by turning it counterclockwise.
2. While pressing the disc lock on the bottom of the unit, thread new disc onto unit by
turning it clockwise and tightening by hand.

inSpeCtion and CLeaninG

Make sure the PAINTEATER™ is turned OFF (O) and unplugged before
performing any inspection or cleaning.
Before using, inspect the general condition of the PAINTEATER™. Check for loose screws, a
cracked, broken, or worn disc, a damaged power cord or any other condition that could affect
the safe operation of the PAINTEATER™. If the PAINTEATER™ makes an abnormal noise or
vibration, take it to an authorized service center for repair. do not use damaged equipment.
iMportant:
Use only a clean cloth and mild detergent to clean the body of the
PAINTEATER™. Do not use solvents or immerse the PAINTEATER™ into any
liquid.
10
Lock
Lock
EN