Installing The Water Dispenser Line - Samsung Rf30Hdedtsr Mode D'emploi

1. Pull out the freezer drawer ( 1 ) to reveal the
lower hinge ( 2 ).
2. Insert a philips screwdriver (+) ( 3 ) into the shaft
( 4 ) of the lower hinge.
3. Adjust the height by turning a philips
screwdriver (+) ( 3 ) clockwise (
counterclockwise (
(1)
When you turn a philips screwdriver (+)
counterclockwise (
move up.
DA68-03028A-06.indb 15
) or
DOWN
).
UP
(2)
(4)
(3)
(3)
), the door will
English - 15
MAKING MINOR ADJUSTMENTS
BETWEEN OUT DOOR AND IN
DOOR
After raising the out door, insert the supplied SHIM
HINGE MIDDLE in the gap between the OUT
DOOR and the HINGE-SHAFT.
SHIM HINGE MIDDLE are enclosed with
the refrigerator.
The thickness of RING is 0.04" (1 mm).
CAUTION
Keep the Rings out of the reach of children and
make sure that children do not play with them or
put them into their mouths.
INSTALLING THE WATER
DISPENSER LINE
A water dispenser with a filter is one of the helpful
features on your new refrigerator.
To help promote better health, the water filter
removes unwanted particles from your water.
However, it does not sterilize the water or destroy
microorganisms. You may need to purchase a
water purifying system to do that.
The water line also connects to the ice maker.
For the ice maker to operate properly, water
pressure of 20 ~ 125 psi (138 ~ 862 kPa) is
required.
If the refrigerator is installed in an area with low
water pressure (below 20 psi), you can install a
booster pump to compensate for the low pressure.
After you have connected the water line, make
sure the water storage tank inside the refrigerator
is properly filled.
To do this, press the water dispenser lever until the
water runs from the water outlet.
2015. 11. 5. 8:09