Zanussi ZYAN8EW0 Notice D'utilisation page 57

Problem
Door is misaligned or interferes
with ventilation grill.
Door does not open easily.
There is too much frost and
ice.
Water flows inside the refriger-
ator.
Water flows on the floor.
The temperature in the appli-
ance is too low/too high.
Possible cause
The room temperature is too
high.
Food products placed in the
appliance were too warm.
The door is not closed correct-
ly.
The appliance is not levelled.
You attempted to re-open the
door immediately after closing.
The door is not closed correct-
ly.
The gasket is deformed or
dirty.
Food products are not wrap-
ped properly.
Temperature is set incorrectly.
Appliance is fully loaded and is
set to the lowest temperature.
Temperature set in the appli-
ance is too low and the ambi-
ent temperature is too high.
Food products prevent the wa-
ter from flowing into the water
collector.
The water outlet is clogged.
The melting water outlet is not
connected to the evaporative
tray above the compressor.
The temperature is not set cor-
rectly.
The door is not closed correct-
ly.
The food products' tempera-
ture is too high.
Many food products are stored
at the same time.
Solution
Refer to "Installation" chapter.
Allow food products to cool to
room temperature before stor-
ing.
Refer to "Closing the door"
section.
Refer to installation instruc-
tions.
Wait a few seconds between
closing and re-opening of the
door.
Refer to "Closing the door"
section.
Refer to "Closing the door"
section.
Wrap the food products better.
Refer to "Operation" chapter.
Set a higher temperature. Re-
fer to "Operation" chapter.
Set a higher temperature. Re-
fer to "Operation" chapter.
Make sure that food products
do not touch the rear plate.
Clean the water outlet.
Attach the melting water outlet
to the evaporative tray.
Set a higher/lower tempera-
ture.
Refer to "Closing the door"
section.
Let the food products temper-
ature decrease to room tem-
perature before storage.
Store less food products at the
same time.
57