Operating Instructions - Drinkwell D360SS-CA-17 Manuel D'utilisation

operating Instructions

Important: DO NOT RUN DRY - FOR INDOOR USE ONLY.
1. As with any electrical device, check the electrical Power
Cord for any tears or damage before use.
2. Make sure the In-Line Plug is connected (fig. 1).
3. Place the Foam Filter around the Pump. The rounded
side of the Foam Filter should be directly in front of the
Faceplate on the Pump. Make sure the electrical Power
Cord runs over the top of the Foam Filter, not underneath it, as this will keep the Foam
Filter in place.
4. With the Foam Filter securely around the Pump, place the Pump inside the indention in
the Bowl. Position the Pump so that the circular opening on the top is in the true center
of the Bowl (fig. 2). Press down on the Pump to engage the suction cups. Place the
Intake Tube into the circular opening on the top of the Pump (fig. 3).
fig. 2
True center of the Bowl
5. Align the Cone so that the electrical Power Cord runs through the Notch (fig. 4)
without moving the Pump from its original position. Once the electrical Power Cord is
aligned, gently place the Cone piece into resting position.
6. Take the partially assembled Filter Housing and remove the
Flow Control Cap by gently lifting straight up - DO NOT
TWIST TO REMOVE (fig. 5). Gently lift up and remove
the Spout Ring to access the Filter Housing Cap.
7. Unscrew Filter Housing Cap and insert the Charcoal Filter
into the Filter Housing with the pull-tab facing up (fig. 6).
The Charcoal Filter will slide easily into place. Next, screw
on the Charcoal Filter Housing Cap.
Important: Rinse the Charcoal Filter thoroughly under cold
water to help remove any loose charcoal dust.
fig. 3
www.petsafe.net
fig. 1
fig. 4 fig. 4
notch
fig. 5
fig. 6
7
.