Drinkwell D360SS-CA-17 Manuel D'utilisation page 10

pet fountain
Important: Clean Pet Fountain once a week.
The Pet Fountain must be cleaned on a regular basis to continue working normally.
1. Unplug Pet Fountain from electrical source
and disconnect the In-Line Plug from the
Pump (fig. 14).
2. Remove the Flow Control Cap and Spout Ring.
3. Next, remove the three Cord Clips by gently
pulling the two-prong clip up and away from the
bottom of the Bowl. Set the Cord Clips aside.
4. While holding the Cone steady, wrap your thumb
and two fingers around the top of the Filter Housing and lift up to remove. If the Filter
Housing is too tight and not moving easily, try twisting the Filter Housing back and
forth in a circular motion until it loosens up enough to remove. Lift the Filter Housing
up and set aside. Most likely, the Intake Tube will still be attached to the bottom of
the Filter Housing.
5. Lift up the stainless steel Cone and set aside for cleaning.
6. Reach in the Bowl and lift up the Pump, remove and set aside for cleaning.
7. Remove the Foam Filter from the Pump. Clean away any hair, debris or pet food that
may have accumulated on the Faceplate of the Pump.
8. While holding underneath the sidewalls of the Bowl, empty the water out of the
Pet Fountain.
9. Clean the Pet Fountain parts with warm water and soap. You can also place the Pet
Fountain in the dishwasher. Important: Do not use any abrasive cleaning solutions,
sponges, or pads that could potentially scratch the stainless steel parts. Remove
the Pump before placing the Pet Fountain in the dishwasher. NEVER PLACE PUMP
IN DISHWASHER! See "Pump Maintenance" section of this Operating Guide for
detailed instructions on how to properly clean the Pump.
10. If you have trouble reaching certain spots or hard-to-reach corners, try using a cotton
swab or purchase the Drinkwell
Cleaning Kit, visit our website at www.petsafe.net to locate a retailer near you or to
find a listing of Customer Care Centre telephone numbers for your area.
10
.
When cleaning your Pet Fountain, do not use any abrasive cleaning
solutions, sponges, or pads. These abrasive surfaces can scratch the
stainless steel parts.
®
www.petsafe.net
fig. 14
Cleaning Kit, a 3-Piece Brush Kit. To purchase a