Pet Fountain Reassembly - Drinkwell D360SS-CA-17 Manuel D'utilisation

pet fountain reassembly

1. Place the Foam Filter around the Pump. The rounded side of the Foam Filter should be
directly in front of the Faceplate on the Pump. Make sure the electrical Power Cord
runs over the top of the Foam Filter, not underneath it, as this will keep the Foam Filter
in place.
2. Replace the Pump into its original location (fig. 19). Be sure that the circular
opening on the top of the Pump is positioned in the Bowl's true center or the Intake
Tube will not properly align with the Filter Housing. Gently push down to engage the
suction cups.
3. Replace the Intake Tube into the circular opening on the top of the Pump (fig. 20).
4. Align the Cone so that the electrical Power Cord runs through the Notch while
keeping the Pump in its original position. Once the electrical Power Cord is aligned
(fig. 21), gently place the Cone piece into resting position.
fig. 19
5. After cleaning your Pet Fountain, it is a good idea to replace the Charcoal Filter. After
replacing the Charcoal Filter, screw on the Filter Housing Cap.
6. Look into the Cone opening and make sure the Intake Tube is sticking straight up from
the Pump. Carefully, insert the Filter Housing into the Cone opening and push straight
down (fig. 22). By pushing the Filter Housing all the way down to the rubber
gasket, the Filter Housing should easily attach to the Intake Tube.
7. Place chosen Spout Ring on top of the Filter Housing Cap and gently press down to
secure in place (fig. 23).
8. Replace the Flow Control Cap by aligning the Flow Control Cap with the raised
notches on the Filter Housing Cap (fig. 24). Gently push down to secure in place.
fig. 22
12
.
fig. 20
True center of the Bowl
www.petsafe.net
fig. 21 fig. 21
fig. 23 fig. 24
raised notches raised notches