Stihl RMI 522 C Manuel D'utilisation page 180

Table des Matières
Les langues disponibles
  • FR

Les langues disponibles

Message:
2077 – Desired zone
Desired zone outside home area
Possible cause:
– The desired zone is outside the stored
home area
Remedy:
– Redefine the desired zone (
Message:
2090 – Radio module
Contact your specialist dealer
Possible cause:
– Communication with the radio module
interrupted
Remedy:
– No action required, firmware will be
automatically updated if necessary
– Contact your STIHL specialist dealer if
the problem persists
Message:
2100 – GPS protect.
Outside home area
Machine disabled
Possible cause:
– Robotic mower was removed from
home area
Remedy:
– Return robotic mower to home area and
enter PIN code (
5.9)
178
Message:
2110 – GPS protect.
New location
New installation req.
Possible cause:
– Robotic mower was operated on a
different mowing area. Wire signal of
second docking station is already
10.)
stored.
Remedy:
– Perform new installation (
Message:
2400 – iMOW® successfully reset to
factory default
Possible cause:
– Robotic mower has been reset to
factory default
Remedy:
– Confirm message with OK
Message:
4000 – Voltage fault
Battery overvoltage or undervoltage
Possible cause:
– Battery overvoltage or undervoltage
Remedy:
– No action required, firmware will be
automatically updated if necessary
– Contact your STIHL specialist dealer if
the problem persists
Message:
4001 – Temperature fault
Outside temperature range
Possible cause:
– Temperature in battery or inside
machine too low or too high
Remedy:
– Allow robotic mower to warm up or cool
it down – observe permissible
temperature range of battery (
11.13)
Message:
4002 – Rollover
see message 1000
Message:
4003 – Hood lifted
Check hood
Then press OK
Possible cause:
– Hood has been lifted
Remedy:
– Check the hood and confirm the
message with OK
Message:
4004 – Drive braking time exceeded
Press OK to release
Possible cause:
– Error in the programme sequence
– Wire routing incorrect
– Obstacles in the area of the perimeter
wire
Remedy:
– Confirm message with OK
– Check wire routing, especially in the
area of the corners, using the
iMOW® Ruler (
– Remove obstacles
6.4)
12.5)
0478 131 9965 D - EN
Table des Matières
loading

Table des Matières